|
The LoRa GPS Shield is an expension board for Arduino with LoRa™ and GPS. This product is intended for those interested in developing LoRa™/GPS solutions.
On the LoRa side, the LoRa GPS Shield is based on the SX1276/SX1278 transceiver. The transceivers of the Shield feature the LoRa™ long range modem that provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption. LoRa™ also provides significant advantages in both blocking and selectivity over conventional modulation techniques, solving the traditional design compromise between range,interference immunity and energy consumption.
On the GPS side, the L80 GPS (based on MTK MT3339) offers exact and quick GPS reading. The L80 is designed for applications that use a GPS connected via the serial ports to the arduino such as timing applications or general applications that require GPS information. This GPS module can calculate and predict orbits automatically using the ephemeris data (up to 3 days) stored in internal flash memory, so the shield can fix position quickly even at indoor signal levels with low power consumption. With AlwaysLocate™ technology, the Lora/GPS Shield can adaptively adjust the on/off time to achieve balance between positioning accuracy and power consumption according to the environmental and motion conditions. The GPS also supports automatic antenna switching function. It can achieve the switching between internal patch antenna and external active antenna.Moreover, it keeps positioning during the switching process.
Features:
- Frequency Band: 868MHz
- Low power consumption
- Compatible with Arduino Leonardo, Uno, Mega, Due etc.
- LoRa™ Modem
- FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation
- Preamble detection
- Baud rate configurable
- Built-in temperature sensor and low battery indicator
- Excellent blocking immunity
- Automatic RF Sense and CAD with ultra-fast AFC
- Support DGPS, SBAS (WAAS/EGNOS/MSAS/GAGAN)
- GPS automatic switching between internal patch antenna and external active antenna
- PPS VS. NMEA can be used in time service
- Support SDK command
- Built-in LNA for better sensitivity
- EASY™, advanced AGPS technology without external memory
- AlwaysLocate™, an intelligent controller of periodic mode
- GPS FLP mode, about 50% power consumption of normal mode
- GPS support short circuit protection and antenna detection
Specifications:
LoRa:
- 168 dB maximum link budget
- +20 dBm - 100 mW constant RF output
- +14 dBm high efficiency PA
- Programmable bit rate up to 300 kbps
- High sensitivity: down to -148 dBm
- Bullet-proof front end: IIP3 = -12.5dBm
- Excellent blocking immunity
- Low RX current of 10.3mA, 200nA register retention
- Fully integrated synthesizer with a resolution of 61 Hz
- FSK, GFSK, MSK, GMSK, LoRaTM and OOK modulation
- Built-in bit synchronizer for clock recovery
- Preamble detection
- 127dB Dynamic Range RSSI
- Automatic RF Sense and CAD with ultra-fast AFC
- Packet engine up to 256 bytes with CRC
- Built-in temperature sensor and low battery indicator
GPS:
- Power Acquisition: 25mA, Power Tracking: 20mA
- Compliant with GPS, SBAS
- Programmable bit rate up to 300 kbps
- Serial Interfaces UART: Adjustable 4800~115200 bps, Default: 9600bps
- Update rate: 1Hz (Default), up to 10Hz
- Protocols: NMEA 0183,PMTK
- Horizontal Position Accuracy: Autonomous <2.5 m CEP
- TTFF@-130dBm with EASY™: Cold Start <15s, Warm Start <5s, Hot start <1s
- TTFF@-130dBm without EASY™: Cold Start <35s,W arm Start <30s, Hot Start <1s
- Dynamic Performance Altitude 18000m, Maximum Velocity 515m/s, Maximum Acceleration 4G
- L1 Band Receiver(1575.42MHz) Channel 22 (Tracking) / 66 (Acquisition)
Documents:
|
