This is the new and improved version of the XBotMicro!
The XBotMicro is a complete low cost lightweight robot base with motors and 3.7V rechargeable battery (140 mAh) ready to carry an Arduino compatible board (even plus a shield) on top.
The integrated LiPo battery allows for hours of autonomous operation, compared to the few minutes that a simpler alkaline battery powered 2WD robot chassis lasts this is a big save in battery cost! Also you don't wast half of your development cycle replacing or charging batteries - the XBotMicro charges while you download new code. This short charging is of the time this sufficient to keep your XBotMicro going the whole day.
Motor drivers and charger are part of the design. The wiskers detect obstacles in front and on the sides (+-90 degrees), with LEDs showing the status.
A switch controls the motor power. Bicolor LEDs show the input status of the motors drivers, so you can test your new code right on your desk without having the XBotMicro literally run away.
Two LEDs indicate the voltage of the battery. When only one led lit, let USB recharge the battery for 2 hours while programming or not..
- 2 hours of autonomous operation
- Max speed ~20cm/s
- Only 40g weight, 68g with an Arduino Uno
- Can carry 500 grams and still move easily
- Dimensions: 102 x 80mm
- Weight: 40g
- BO30 motors
- CS7721 driver
- 250mAh LiPo battery
- LTC4054 charger
- Fully assembled board with motors, wheels, battery, wiskers, 3 connectors.
- 4x M3 screws
- 8x 10 mm spacers
- 10x 70mm jumper wires with 0.6mm pins
Connect the power and signals according to documentation. You are of course free to to use different signals, e.g. use 4 pwm channels.
|| CHF 51.16
This item is limited to 1 pcs per order.