|
This product is currently out of stock. You might want to set a notification to receive a short one-time email when the product returns to stock next time.
Teensy 4.1 features the fastest microcontroller and an expanded set of powerful peripherals in a 2.4 by 0.7 inch form factor.
The Teensy 4.1 can be programmed using the Arduino IDE with Teensyduino add-on.
Technical Specifications Compared to Teensy 4.0:
Teensy 4.1 & 4.0 use the same IMXRT1062, so most technical specifications are the same.
Please refer to the Teensy 4.0 page for common specifications and features.
| Feature | Teensy 4.1 | Teensy 4.0 |
|---|
| Ethernet | 10 / 100 Mbit
DP83825 PHY
(6 pins) | -none- |
| USB Host | 5 Pins with
power management | 2 SMT Pads |
| SDIO (4 bit data) | Micro SD Socket | 8 SMT Pads |
| PWM Pins | 35 | 31 |
| Analog Inputs | 18 | 14 |
| Serial Ports | 8 | 7 |
| Flash Memory | 8 Mbyte | 2 Mbyte |
| QSPI Memory | 2 chips
Plus Program Memory | Program memory only |
| Breadboard Friendly I/O | 42 | 24 |
| Bottom SMT Pad Signals | 7 | 16 |
| SD Card Signals | 6 | 0 |
| Total I/O Pins | 55 | 40 |
Pinouts:
The Teensy 4.1 is designed to bring all general purpose I/O pins to breadboard friendly pads on the outside edges.
Ethernet:
To use the Ethernet port, a magjack and capacitor need to be connected.
This is currently available only as a DIY project using this OSH Park Shared Circuit Board. PJRC is planning to offer this as a DIY kit in the near future.
Memory Expansion:
The bottom side of Teensy 4.1 has locations to solder 2 memory chips.
The smaller location is meant for a PSRAM chip. The larger location is intended for flash memory.
USB Host:
Teensy 4.1's USB Host port allows you to connect USB devices, like keyboards and MIDI musical instruments. A 5 pin header and a USB Host cable are needed to be able to plug in a USB device.
USB hubs may be used if more than 1 device is needed. See the USBHost_t36 examples for details.
Documents:
|
