This breakout board for the popular Nokia6100 knock-off color LCD has an improved backlight driver circuit (boosts to 7V), a tri-color status LED and 2 pushbuttons. All accessible through one 9-pin 0.1" spaced header. Vbat and the 3.3V input can be driven from the same regulated 3.3V source, but the device will draw more current than if the Vbat input was driven from a higher source voltage. For an estimate of the current draw for a given input voltage, refer to the chart on the schematic file below.
This breakout is set up for serial communication to the display and comes with the Nokia 6100 display attached as shown in the picture.
- Based on Philips PCF8833 controller
- Nokia LCD6100
- Backlight PWM control "BKL"
- 128 x 128 pixels
- 12-bit color rendition (4-bit red, 4-bit green, 4-bit blue)