|
This Bluetooth shield is a serial port Bluetooth module (Master and Slave) breakout board, and it compatible with Arduino, you can directly plug in with Arduino and use the UART port for Bluetooth communication.
It's the new and improved version of BT shield v1.1 and BT shield v2.1
What's new in v2.2 ?
- Now the new shield is full Arduino footprint , and add the stackable socket for connecting with other Arduino shield like Ethernet shield , SD card shield.
- Free UART connection setting. You can use from D0,D1, D4-D7 as UART pins, not just the D0, D1.
The BT shield v1.1 just can communicate with Arduino board, and it’s inconvenient to change its setting by AT command through USB. Now the new board has a switcher, you can change the module connection, so when you put the switcher to the “To Board” side, it can control by Arduino or IFLAT32, but to “To FT232” side, it connect to the FT232D IC, you can use the Arduino IDE or other serial monitor software to send it the AT command.About the AT command , you can find more detailed information below.
- In the free area, we provide you a prototype area, and you can build a small circuit there for your Bluetooth
AT command set:
1. Communications Test:
Sent : AT
receive : OK
2. Change baud rate:
Sent : AT+BAUD1
receive : OK1200
Sent : AT+BAUD2
receive : OK2400
1---------1200
2---------2400
3---------4800
4---------9600
5---------19200
6---------38400
7---------57600
8---------115200
Baud rate setting can be saved even when power is down.
3. Change Bluetooth device name:
Sent : AT+NAMEdevicename
receive : OKname
(devicename is the name you want the device to be , and it will be searched with this name)
Name setting can be saved even when power is down.
4. Change Pincode:
Sent : AT+PINxxxx
receive : OKsetpin
(xxxx is the pin code you set)
Pin code can be save even power down.
Documents:
|
